When calculating a connection using the FRAME‑JOINT Pro add-on module, a message appears saying that the value is out of the valid range (existing value: 108, minimum value 100, maximum value 100). What does this message mean?
Is the preset crack width of, for example, wk = 0.3 mm also designed for primary cracks? According to the manual, the average strain is considered. Does this ensure that the primary crack does not exceed the value wk = 0.3 mm?
I would like to use the CRANEWAY add-on module to design a suspension crane. Where are design points 0, 1, and 2 for the stress analysis on the bottom flange and for the fatigue design?
When entering surface loads, it is possible to enter a correction factor to consider the effects of continuity. For the external members or supports of a continuous beam, the factor 0.8 is entered in the model that I have from my colleague. Should the factor for the external section not have to be 0.4?
I want to design a crack width of 0.1 mm in RF‑CONCRETE Surfaces. But when entering "0.10 mm" as the limit value, I get an error message saying that only a value between 0.2 to 0.4 mm can be designed.
I would like to remodel a connection using FRAME‑JOINT Pro for comparison purposes, but I am having problems with the bolt spacings. Are there any other spacings, or have I overlooked something?
When generating loads with a different arrangement of members within the load plane, I obtain incorrect load values. Why is the load not distributed correctly?